Hello Expert, I have to two fortigate 400e in HA setup, but I am unable
to connect to standby one when I use the Management port on the device,
How can I log into the device when it is standby mode?. Thank you
Regards
Hello Expert, I was able to successfully create an IPsec tunnel between
Palo alto and my FortiGate.I am seeing ping and http traffic success
leaving my FortiGate but the return traffic is being deny below is
details of a deny packet GeneralAbsolute D...
Hello Expert, I have configure a "vpn" tunnel between FortiGate 80F a
Palto Alto device.The wan interface of the Palto Alto device is using
private ip address for the wan interface because the another device on
the network is use for full internet ac...
Hello Support, I have one Fortinet 524 D switch on my network .I also
have (4) Fortinet 448 switches and (8) Fortinet 424D switches on my
network.I would like to connect all the 12 Switches (448 and 424D) to
the 524D, effectively making the 524D swit...
Hello aionescu, The are two policy in place see below for the details
BOG_PROD1 (1) # showconfig firewall policyedit 1set name bog_outset uuid
06077bd6-2ae1-51ed-de80-ac765ef0ed51set srcintf internal1set dstintf
RBGL_BOGset action acceptset srcaddr a...
Hello FortiMax, I am unsure why we have to select Dialup User as the
Remote gateway, I have created an ipsec vpn from Fortigate to Palo alto
.I would like to send the Fortigate configs to you but I am not seeing
any option on the portal to allow uplo...
Hello FortiMax_it Sorry for the late response I was on vacation i using
the following version I am only getting the peer id option if I using
ike v1 but ike v2 is required for vpn connection to palo Alto Unsure how
to get the peer id option when usin...