Hello everyone, I'm trying to setup my 40c with multiple virtual
interfaces. I simply followed this guide:
http://kb.fortinet.com/kb....do?externalId=FD33738 Which basically comes
down to: #FGT40C-3 # config system interface #FGT40C-3 (interface) #
e...
Finally, its working!Turns out I made two mistakes:1) I didn't set the
VLAN tags on the physical port my Fortigate was connected to (I know,
floolish of me...)2) I didn't enable ping on my DMZ interface (which I
was trying to ping all the time...) Bi...
Here is a screenshot of my routing table: As you point out, port 2 is
the only port carrying the VLAN tags, and this is correct because port 2
is where my NUC (with ESXi) is connected to. And this is where the VLAN
tags are divived into seperate virt...
Hello guys, apologies for the late reply. I tried/checked all of the
above (re-entered the route), but i don't see any traffic from VLANs 200
when I enter 'diagnose sniffer packet internal'.And I'm pretty sure the
VLANs are correct because is basical...
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
