Hi Everyone,I can't get any data from processes in FortiSIEM.I have
configured snmp in the hosts, and when i do snmpwalk on the collectors
the data is valid and shows if that the process is running or is
stopped.But in the SIEM no data is shown.Am i ...
Hi Everyone,I can't get any data from processes in FortiSIEM.I have
configured snmp in the hosts, and when i do snmpwalk on the collectors
the data is valid and shows if that the process is running or is
stopped.But in the SIEM no data is shown.Am i ...
Hello again Dan,I have been monitoring some system services like rsyslog
and sshd.But the are constantly with the process down due to the threads
they create.How do you handle this?Because the incident creation will go
nuts..Tanks in advance,Best Reg...
Hello again Dan,I have been monitoring some system services like rsyslog
and sshd.But the are constantly with the process down due to the threads
they create.How do you handle this?Because the incident creation will go
nuts..Tanks in advance,Best
Reg...
Hello Dan,Thank you.I was reading about that, and i was afraid of what
it would do if i turned it on.I will explicitly add all the processes,
and check if all is ok.Thank you very much.Best regards,Sam
Hello Dan,Thank you.I was reading about that, and i was afraid of what
it would do if i turned it on.I will explicitly add all the processes,
and check if all is ok.Thank you very much.Best
regards,Sam-------------------------------------------Origin...
Hello Dan,Thank you for your reply.I have done that with only snmp
discovery.But still it only show as follows, and no process status: I
still cant find where to configure the sys monitor.Do you have a
clue?Thanks in advance.Sam.
