Folks, simple question I have two interfaces and devices attached with
statically set IP addresses in the same scope (they talk fine when
attached to a switch or crossover cable) what policy / route to I need
to have the Fortigate allow traffic betwe...
I could, but then couldn' t manage traffic between them. The answer
turned out to be a CLI only command to allow subnet overlap. Thanks for
the ideas everyone.
A little more on this. BTW the reason I' m doing this is that I' m
swapping out a Fortigate which is used in Transparent mode with a much
larger one that I' m going to use in NAT mode. But I would like to not
have to redo my network scheme at this ti...
Yes, I get it. If you wanted to use this configuration how would you set
the routes? Example Port 3 device 10.10.10.10 Port 4 device 10.10.10.11
What would the routes look like? Thanks guys!
Dave, thanks for the reply. NAT is not enabled, good thought though. I
do have two policies so between them in both directions it' s
any.any.all.all The interfaces both indicated UP, but I' ll try the
speed suggestion. BUT, I' m not crazy right - thi...