Hi Fortinet Team, We are trying to bring up Dial-up vpn tunnel between
FortiSASE POPs and Fortigate SPA Hub. Fortigate SPA Hub BGP neighbor
range is 172.31.2.0/24. Fortigate SPA Hub loopback ip is
172.31.2.1/32Spoke ip is 172.31.2.2/32But when we ass...
Hi Fortinet team and all, I would like to understand deep and dive
technical functionality of passive WAN health measurement. Could anyone
share document to understand it? LikeHow it is calculating the jitter,
packet loss and latency through TCP sess...
Hi Fortinet Community I need some clarification on Forward Error
Correction. Does FortiGate VMs support Forward Error Correction (FEC)?
As per understanding NP, SOC3 or SOC4 one of the chips should be present
in the FortiGate device to enable FEC and...
Hi @Anonymous , I have checked my FortiGate firewall session table for
the firewall policy where passive wan health measurement is enabled. I
found that there are zero sessions as below. Firewall policy:Session
list: But still passive SLA is showing ...
Hi @Anonymous , Thanks for the prompt reply. sorry to say this but the
answer you have given is not correct one to my question. If there are 10
TCP session with different destination, each TCP will have different SLA
metrics, how the FortiGate firewa...
Hi @Anonymous , Thanks for your reply. I have a doubt like once we
enabled passive WAN health measurement in firewall policy. There would
me plenty of internet traffic say for example 10 different internet
traffic, each of the internet traffic will b...
Hi @srajeswaran, There are totally 4 dial-up VPN tunnels between hub and
spoke. Is there any data sheet available to be consider while enabling
FEC with information of minimum CPU, RAM ?
Hi @Shilpa11, Thanks for your reply. I have understood how to configure
the FEX in fortigate but how does FEC work in FortiGate (Workflow)? Is
there any document to refer else can you tell it? Once FEC Enabled in
VPN tunnels - All the traffic passing...
