Hi, I am not sure if this is a Fortinet or Windows issues, but just
wanting to know if anyone else has experienced the issue I am having.I
have a working VXLAN over IPSec working. I can stand up Windows 2019
servers at both ends of the tunnel and at ...
I have setup two sites with a Fortgate 100F device (7.0.5) at each site.
I have set-up and have operational a vxlan connection between the two
sites over an IPSEC tunnel. At site A there is a monitoring VM with a
fixed IP address (192.168.200.2/24 GW...
Thanks Adrian, I changed HA setting at one end of the vxlan for the
group-id. Changed from 0 to 1. The change did caused a failover of the
Fortigate deviceSet-up a new software switch (had a different MAC
address) and now able to access the gateway d...
Hi, ARP Test VM ARP Monitor VM MAC Addresses are the same Wireshark
output from Site B Fortigate No ping traffic from test VM to gateway
address - So failing to traverse the tunnel? But has learnt the MAC
address. SA information is just src 0.0.0.0/0...
Site A - diag sniffer packet any "host 192.168.200.241 and icmp" - Test
VM Site B - diag sniffer packet any "host 192.168.200.1 and icmp" Same
behavior as shown in the packet captures. Stephen
