Description This article describes how to block anycast address in
Geo-IP blocking using a deny policy. Scope FortiGate. Solution Anycast
IP is shared between multiple servers and they can be in different
locations as well. The objective is to block ...
Hello Simon, Thank you for reaching out TAC support. In order to make
them sync in config you can refer the below article REF:
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Procedure-for-HA-manual-synchronization/ta-p/196067
Regards, Piyu...
Hello RDP, Thank you for reaching out fortinet support. From the logs it
looks like unknown users are trying to access your VPN Service. In order
to secure your network please refer the below articles:
https://community.fortinet.com/t5/FortiGate/Tech...
Hello @RolandBaumgaertner72 , Thank you for reaching out to fortinet
support. In order to bring your device up and back in HA Sync, first
take the node2 out of HA cluster along with LAN and wan access, then
management access of the Node2 Upload the c...
Hello Slizzard, Thank you for reaching out to support portal. I would
recommend you to capture the debugs on the FCT itself and look into the
logs there. REF:
https://community.fortinet.com/t5/FortiClient/Technical-Tip-How-to-enable-debug-log-in-Fort...
Hello AEK, Thank you for updating on Fortinet support forum. Definitely
it comes with many interesting features and in order to configure them
you can refer the below admin guide. REF:
https://docs.fortinet.com/document/fortigate/7.6.0/administration...
