Description This article describes some useful commands to troubleshoot
common issues with the FortiGate Transaction Mode or before raising a
ticket with the Fortinet Technical Support. Scope FortiGate. Solution
When using the Workspace Mode in Forti...
Description This article describes how to collect WAD debug logs on a
FortiGate-7000 (or 6000) series chassis.In a FortiGate-7000 (or 6000)
series unit, the FIM (or MBD) is the slot responsible for load-balancing
the data plane traffic and forwarding...
Description This article explains how to make sure that the GTP traffic
hitting a specific firewall policy will not be inspected when a GTP
profile is removed from a firewall policy. Scope FortiCarrier, GTP.
Solution On FortiCarrier, when a GTP profi...
Description This article clarifies that a FortiSwitch FS-M426E-FPOE does
not support UPoE 802.3bt standard, and it is not able to provide full
power to a FortiAP-431G through a single interface. Scope FortiSwitch
FS-M426E-FPOE and FortiAP-431G, all f...
Description This article describes how FortiGate blocks the TLS
Encrypted Client Hello (ECH) and forces the end client to send the inner
SNI in clear. When using the Encrypted Client Hello (ECH), the TLS 1.3
protocol may split the Client Hello messag...
Hi @Borys_DE , Correct, if one of the Aruba switches dies, the spanning
tree will be recalculated and the traffic will go through the other
Aruba switch. Best regards,
Hi @Borys_DE , Regarding your doubt:>>"But the lack of any settings on
the FortiSwitches side confuses me. MCLAG must be configured on both
sides, otherwise it simply does not work."If you want to have MCLAG from
the point-of-view of the FortiSwitche...
Hi @Borys_DE , You do not see VLAN 4094 on FortiGate GUI because it is
the default management VLAN for managed FortiSwitches.Regarding your
question:>>"Should I create a new VLAN with ID 4094 or is it better to
change the native VLAN on Aruba?"I woul...
Hi @Deepfriedrolos ,Thank you for letting me know.I would suggest you to
run a packet capture on the Netgear port and on the FortiSwitch related
ports, then analyse them with Wireshark and compare.The article below
might help with FortiSwitch packet ...