Technical Tip: How to capture packet traffic at th...

wdeloraine_FTNT · 09-24-2025

Description This article describes how to avoid common issues after a certificate change bound to a captive portal. Scope FortiGate. Solution Captive portals are usually secured behind a SSL certificate. Issues may occur when this certificate is chan...

wdeloraine_FTNT · 09-24-2025

Description This article describes how to test the bandwidth of a link. Scope FortiGate. Solution UDP testing is preferred when it comes to link bandwidth testing like a WAN link. Packet loss is not considered when using UDP. Data payload can be sent...

wdeloraine_FTNT · 07-31-2025

Description This article details the process of fragmented packets on chassis-based FortiGate. Scope Chassis-based FortiGate-6000F, 7000E, and 7000F Series. Solution Default Configuration: config load-balance setting config workers edit 3 next edit 4...

wdeloraine_FTNT · 06-10-2025

Description This article describes the behavior when dynamic routing is used along with IPSEC load-balance on chassis-based FortiGate. Scope FortiGate-6000 and 7000 series. Solution Prerequisites: Dynamic routing traffic, such as OSPF, BGP, or RIP, i...

wdeloraine_FTNT · 04-22-2025

Description This article describes how packets are processed when they match a flow rule. Scope FortiGate-6000F, 7000E and 7000F series. Solution On chassis-based FortiGate, a packet eligible for load-balancing goes through to the FPM in this order: ...

wdeloraine_FTNT · 08-14-2024

No you will need an external device for that.

wdeloraine_FTNT · 08-14-2024

Hi, You can do this by using virtual cluster feature in HA. Here's the documentation link: https://docs.fortinet.com/document/fortigate/7.4.4/administration-guide/599385/ha-virtual-cluster-setup

wdeloraine_FTNT · 12-11-2023

Hi, additionally, try to check MD5 hash of your image file to be sure that the firmware is not corrupted.W.

wdeloraine_FTNT · 10-05-2023

Hi, We can imagine some solutions as the behavior of verizon gateway is not known: bridge mode could be configure on the verizone gateway only router mode is supported With bridge mode, the fortigate will get the public IP from the ISP. With router m...

wdeloraine_FTNT · 10-05-2023

Hi, Usually VLAN1 is reserved for internal use. It depends of the hardware you have but if it's not working for VLAN1, most likely VLAN 1 is used by FortiOS. https://docs.fortinet.com/document/fortigate/7.2.6/fortigate-6000-administration-guide/72935...

User Statistics

User Activity

Troubleshooting Tip: How to avoid capture portal issues after a certificate change

Technical Tip: How to test the bandwidth of a link

Technical Tip: Packet fragmentation for chassis based FortiGate

Technical Tip: Use dynamic routing and IPSEC load-balance on FortiGate-6000 and 7000 series

Technical Tip: Packet processing with flow rule

Re: VDOM Failover Configuration for FortiGate Firewalls

Re: VDOM Failover Configuration for FortiGate Firewalls

Re: installing firmware from system reboot

Re: Connect Verizon Interney Gateway to Fortwifi 60e

Re: vxlan for vlan1

Technical Tip: How to capture packet traffic at th...

Technical Tip: Restore multicast traffic after a f...

Technical Tip: How to receive a multicast stream i...

Technical Tip: How to receive a multicast stream w...

Technical Tip: How to restore a chassis based Fort...

Re: VDOM Failover Configuration for FortiGate Fire...

Re: vxlan for vlan1

KCS

User Statistics

User Activity

You are leaving our website