I am testing moving off a software proxy and trying to setup flowbased
on a fortigate 60c right now I have some basic content filters turned
on(that I already run on traffic and works fine) on the test profile I
added a single block url to the test w...
This account has worked fine before, other accounts are working fine,
all in the same group " I am currently getting a " Error:Permission
denied" error with the note to wait 10 minutes and try again" Should I
just reset the password and have them try...
replacing my wifi setup that was just 2 linksys routers running ddwrt
with ubiquity unifi' s(fortiap' s were not in the budget) plan was to
put them on their own subnet ie main ips subet is 192.168.1.0 and these
would then live on .2.0 added secondar...
so I have a 40C dial up VPN' ing to a 60C the 40c is throwing an '
unknown or bad host' when I tracert it to 10.10.10.10 now I have routes
for 192.168.1.0 and 10.0.0.0 to the interface for the
VPN(to_main_office) the 192 routes work fine, the 10.' s ...
doesnt load, or is very unresponsive. I can get the dashboard but thats
pretty much it. was working fine on patch 5 have tried IE8 and 9, the
current version of chrome I' m in the middle or trying to deploy a 40C
for a VPN link to the 60 and its hard...
nat issue the great thing about making a forum post and taking a day off
is having to go back with fresh eyes to answer your questions thanks for
being the OTHER guy in the office guys
ORIGINAL: rwpatterson The onus is on you to determine if a newer patch
has resolved your issue. We' re not going to do your homework. (at least
I' m not!) sorry wasn' t inferring you needed to. I haven' t had time to
get into the release notes, as th...
ORIGINAL: pcraponi Move to the last MR3 version (patch14) and try again
um....no? unless its a known bug for the version I am on that doesnt
make sense. if its a known issue I' m happy to move to a newer patch
though ORIGINAL: Dave Hall I assume you ...
ORIGINAL: SecureLayers-Eric You can NOT use a DHCP server on a secondary
IP address range on the interface. It' s by design. Use a VLAN for your
wireless DHCP Sorry for the omission, quite important. so the ubiquitis
will assign vlan tags to each of ...
