Re: Conserve Mode, FGT-60F & FortiOS 7.4

dbhavsar · 12-09-2025

Description This article describes how to resolve an error 'failed to get service tag addresses' when fetching service tags from Azure SDN connector configured on the FortiGate. Scope FortiGate. Solution This article describes a situation where the S...

dbhavsar · 12-03-2025

Description This article describes how to resolve the error 'ERR: NO MEM for USER_LOCAL_MSG' when FortiAP is not coming online. Scope FortiGate. Solution Execute the WTP debugs on the FortiGate to find at which point the FortiAP connection is failing...

dbhavsar · 11-25-2025

Description This article describes how to view the real-time transmit (Tx) rate and receive (Rx) traffic rates (bandwidth usage) for a specific port or all ports, and view port settings. Scope FortiSwitch. Solution To check the port speed on a FortiS...

dbhavsar · 11-02-2025

Description This article describes SSLVPN connection fails after changing listening interface for SSL VPN settings. Scope FortiGate. Solution Even after changing the listening interface from the GUI's SSL VPN settings, the previous interface that was...

dbhavsar · 10-13-2025

Description This article describes the creation of an automation stitch that schedules a reboot for downstream devices in the security fabric. Scope FortiGate. Solution If the device is in a security fabric, an automation stitch can only be configure...

dbhavsar · 03-17-2025

Hello @hyder ,Have you tried deep packet inspection, and also what mode is configured on the policy [flow/proxy]. You can try creating a test policy and test using Deep packet inspection + Proxy mode and Deep packet inspection + Flow mode. Also what ...

dbhavsar · 03-17-2025

Hello @hyder , From Application Control profile have you tried blocking "Apple.Messages" ? Reference: https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-block-particular-application-using/ta-p/357034

dbhavsar · 02-27-2025

Good day @Floh , - Can you enable FEC on both sides, specifically with cl74-fc-fec? If that helps to bring link up or not. - Also you can collect following debugs and open up a TAC case for further investigation:config sys interfaceedit sh fu | grep ...

dbhavsar · 02-27-2025

Good day @IrbkOrrum , - If the tunnel is between 2 FortiGates it's fine to use wizard that will create policy, routes and will add default ENC and AUTH protocols. But if you are configuring tunnel to 3rd party firewall you might need to modify ENC an...

dbhavsar · 11-28-2024

Hello @MichaelHinz , Can you run command "get sys status", there you will be able to see the part number of the device being used.

User Statistics

User Activity

Troubleshooting Tip: Azure SDN connector Error 'failed to get service tag addresses'

Troubleshooting Tip: Error 'ERR: NO MEM for USER_LOCAL_MSG' in wireless-controller debugs.

Technical Tip: How to view real-time transmit (Tx) and receive (Rx) traffic rates (bandwidth usage) for a specific port or all ports and port configuration

Troubleshooting Tip: SSL VPN does not works after changing listening interface

Technical Tip: Configuring an automation stitch to reboot downstream devices in the security fabric

Re: Unable to block imessage application signature in Fortigate

Re: Unable to block imessage application signature in Fortigate

Re: Fortigate connection to Cisco 25G/SFP28

Re: "Custom" tunnel vs "Site to Site - FortiGate"

Re: Fortigate Rugged 60F unable to HA sync after FortiOS upgrade to 7.2.x

Re: Conserve Mode, FGT-60F & FortiOS 7.4

Re: Conserve Mode, FGT-60F & FortiOS 7.4

Re: Current Bandwith Monitor

Re: Captive Portal redirection

Re: IPSEC Tunnel doesn't match user in incoming tr...

Re: internet service database

Re: Redistribute IP in OSPF

Re: To restore configuration to the FortiGate by u...

Re: 2 VIP with same external IPs

Re: Security POP

KCS

User Statistics

User Activity

You are leaving our website