Description This article describes why Android devices are unable to
connect using IKEv2 with Username and Password with a Preshared key used
as an authentication method. Scope FortiOS, FortiClient Android.
Solution When connecting to an IPsec IKEv2 ...
Description This article describes where to find the Account ID and
Alias information for IAM users. Scope FortiCloud. Solution Once the IAM
user is created during the login process of the IAM user an Account ID
or the Alias information is needed wit...
Description This article describes the reason why FortiGate generates
logs about FortiGate Cloud server disconnection and reconnection. Scope
FortiOS. Solution Under system events logs, the following logs are seen:
This disconnect usually happens eve...
Description This article describes the best way to troubleshoot a dead
interface on FortiGate. Scope FortiGate. Solution If a port on FortiGate
seems to be dead or non-functional, a loopback test is the best way to
consider as part of troubleshooting...
Description This article describes how to access a managed FortiAP GUI.
This is mostly helpful when FortiAP shows offline due to firmware
compatibility with FortiOS, meaning a firmware upgrade on the FortiAP
will become easier through the GUI. Scope ...
I'm not recommending to use redundant link setup on FortiGate because
when you place this interface in monitor interface on HA on fortigate it
will not go down until both link fails
Hence both the switches are working independently a LACP or port channel
will not form , from your topology your 2 LACP ports from the FGT are
also connecting to 2 different switch here, your solution would be
either use one switch , or stack the swi...
To troubleshoot this : 1) Please install a wireshark on the client
machine and check if the VPN traffic is even generated or leaving
through the computer 2) If the traffic is not seen on capture then it
simply means that its an issue on endpoint, 3) ...
when you have a manual rule then the first selected WAN interface will
be used and then the second, Also note that SD WAN rules are policy
routes, To verify the proute traffic please refer this article:
https://community.fortinet.com/t5/FortiGate/Tec...
Once you enable the exclusive routing the on-link won't be able to get
any traffic so I can't think of any way how your VM's can even
communicate , I don't think its even possible may be it could be by
creating a static route entry on your computer a...
