Hi,I need to use an internal interface (port 3) of my Fortigate 100D
(fortiOS 5.6) as a WAN port.When the cable is connected to the WAN port
I get DHCP IP without any issues but when I move it to the internal
interface (port 3) I do not get a DHCP IP...
Hi! I am having some issues with this current network design we
have.Main office: IP: 172.25.65.166/24 GW: 172.25.65.165IP:
172.25.65.166/24 GW: 172.25.65.165Data Center:GW: 172.25.65.93 ----->
vlan200 172.25.65.94/30 (port1)The internal LAN on the F...
rwpatterson wrote:aespinola wrote:@rwpatterson, thanks for answering.
Could this bad subnetting be the cause of me not being able to reach the
lan? On the routing table on my DC I see 172.16.25.29/30 as a connected
route. Would it work if I change my...
@rwpatterson, thanks for answering. Could this bad subnetting be the
cause of me not being able to reach the lan? On the routing table on my
DC I see 172.16.25.29/30 as a connected route. Would it work if I change
my /24 of my office to a /30 too?. A...
Yes, that is correct. I was told by the ISP that they (office and DC)
are connected through Layer2 on a separate VLAN, in this case, is the
VLAN that is on the port1 of the Fortigate on the DC.
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
