Hi friends, perhaps you can help?I have two different networks (NW1 and
NW2). NW2 can only be reached when i use a sprcific IP as next-hop or
Gateway from NW1. At the moment i can't reach NW2. Is there something i
do wrong? - I added NW to WAN1 and N...
Hi friends,perhaps someone can help. I have two Fortigates connected via
site-to-site vpn.From both networks, Site A and B, i can reach the
networks. My dial-up users inform me, that they can't reach the site b
network. With their dial-up connection,...
Hi Erlin,can't check the upstream device because its on the providers
side.In my opionion, my config is correct because on the policy lookup
matches, the routing table shows that the route to NW2 is known. Not
sure, what to do now. I tried to apply a...
Hi Erlin, checked this. No Packets will received by sniffer, the
Debugger shows also nothing.The routing table tells me, that the NW2 is
known via WAN1. The router info for the destination ip is known via
static and directly connected to wan2. Do you...
Hi, will try to make it clearer. from my provider i got two networks.NW1
and NW2 (for my services with some public IPs set to this network) Two
cables. Both of them have the same configuration, so i can use both or
just one cable.In my setup i use bo...
Hi sw2090 and Debbie,i was able to solve my problem. sw2090 i had the
same thought that the client doesn't have the route. That was true, the
route wasn't available on the client.I missed to add on the dial-up vpn
connection the side b network as acc...
