Re: Alarm Button -PSU

parteeksharma · 12-21-2025

Description This article describes how to configure subnet-based syslog filtering on FortiGate devices, allowing users to filter traffic logs based on specific source or destination IP addresses. Scope FortiGate. Solution To configure subnet-based sy...

parteeksharma · 10-29-2024

Description This article describes how to use the Exempt option in the Webfilter URL filter to control scanning. Once the Exempt is enabled in the URL filter for any URL, the URL will bypass all other scanning such as antivirus or DLP, etc. There is ...

parteeksharma · 10-28-2024

Description This article describes the feature to enable 'Dynamic address' under policies and block devices based on the OS detected. Scope FortiGate v7.4 and above. Solution This feature relies on device detection configured on the interface connect...

parteeksharma · 09-24-2024

Description This article describes the DHCP relay behavior with the deny policy (Firewall policy) configured on FortiGate. To send the DHCP 'Discover' packets to the server, the Firewall does not check the traffic policies configured, and the traffic...

parteeksharma · 09-24-2024

Description This article describes the case when the options to Clone and enable/Disable the SD-WAN rule page is missing on FortiGate under the Network tab. Scope FortiGate-101F. Solution While modifying an SD-WAN rule through GUI, the option to Clon...

parteeksharma · 09-22-2024

Hi kazzax,Hope you are doing good.You can factory reset the box using below:https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-reset-a-FortiGate-with-the-default-factory/ta-p/196896Regards,Parteek

parteeksharma · 09-22-2024

Hi bessad,Hope you are doing good.Actually, this situation to go for which certification solely depends on you. CCNA is basics of networking fundamentals and cover the topics and basic understanding of networking concepts and protocol behavior accord...

parteeksharma · 09-11-2024

Hi Ninio,Hope you are doing good.You can use following article to achieve split tunnel with IPsec VPN for clients:https://community.fortinet.com/t5/FortiGate/Technical-Tip-Enable-split-tunnel-For-IPsec-VPN/ta-p/192266Regards,Parteek

parteeksharma · 09-10-2024

Hi Yahyaflaifel,It would be better to open a TAC case for this specific issue and share the output of below if you are still facing the issue, so that it could be checked further.get system statusget system performance statusexec tac reportRegards,Pa...

parteeksharma · 09-09-2024

Hi CEMS,Hope you are doing good.Please be informed that different hardware models have different Front Panel and LED status information and also for most of the devices Power and Alarm LED have different functioning. Kindly check the below link for L...

User Statistics

User Activity

Technical Tip: How to configure Subnet-Based Syslog filtering on FortiGate

Technical Tip: How to use Exempt option in Webfilter URL filter to control scanning

Technical Tip: Blocking device based on OS detected using Dynamic address options under Firewall Policies

Technical Tip: The DHCP relay agent behavior with the deny policy (Firewall policy) configured on FortiGate

Technical Tip: Options to Clone and Enable/Disable the SD-WAN rule is missing on FortiGate under the Network tab

Re: Factory reset 500D

Re: Should I go For CCNA or FCP?

Re: IPSEC VPN - split tunnel wont work

Re: cannot access FG 50E through LAN ports