Description This article describes the steps to set up SD-WAN dial-up
VPN using BGP routing. Scope FortiGate. Solution Objective: Dial-up
IPsec VPN connection between two FortiGates. Using two ISP to establish
VPN connections between each other for t...
Description This article describes the OID value for a power supply in
FortiOS. Scope FortiOS v7.2.6 onwards. Solution Example FortiGate Model:
FGT601E. The FortiGate SNMP returns as 1 when the NMS query for the PSU
status is 'OK'. By default, FortiG...
Description This article describes when IPSEC overlay members are added
to SD-WAN and have issues with performance SLA being down. Scope
FortiGate SD-WAN SLA. Solution FortiGate can still ping the detect
server. But the SLA is showing 'dead' for one ...
Description This article describes how to fix some cases of slow webpage
loading by whitelisting the ad-serve domain integrated with the site.
Scope FortiGate version 6.4 and above.FortiGate version 7.0 and above.
Solution Sometimes, web pages load s...
Description This article describes how to ensure ping is reachable to a
FortiGate WAN IP in the Dashboard with VIP configured. Scope FortiGate
6.4.8 and below. Solution A test ping failure to the FortiGate WAN IP
shows in the dashboard from the inter...
Hi there, Please see if the article here fixes your issues.
https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-Lost-internet-connection-when-connecting-SSL/ta-p/286345#:~:text=To%20resolve%20this%2C%20either%20create,once%20VPN%20connect...
Hi, Two way here, but its all depend on your requirement at last. Idea
is just to route/allow the traffic through required port. - You may find
article here to configure port forwarding using VIP for any custom
ports.
https://docs.fortinet.com/docume...
Hi, - whether it is sslvpn web mode or tunnel mode? - You may verify the
setup sslvpn with ldap by referring to doc link here.
https://docs.fortinet.com/document/fortigate/6.4.2/administration-guide/115783/ssl-vpn-with-ldap-user-authentication
- what...
Hi, You may refer link here to find out possible cause for route not
advertise to the neighbor.
https://community.fortinet.com/t5/FortiGate/Technical-Note-Common-issue-when-trying-to-advertise-a-subnet-to/ta-p/193295
https://community.fortinet.com/t5...
Hi, - if the failover WAN stop passing the traffic, check whether the
port Tx & Rx counters of the port incrementing.
https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-FortiGate-interface-error-counters/ta-p/190190
- Try to check if any...