Description This article describes how to resolve the invalid status
error for a certificate that occurs when the FortiGate system time is
incorrect. Scope FortiGate. Solution On the FortiGate, under System ->
Certificates. Several certificate shows ...
Description This article describes the issue where an admin is unable to
view the DNS database despite having an admin profile with read/write
'network' permissions. It provides a solution to resolve this issue by
configuring the admin profile with t...
Description This article describes how to resolve a remote access issue
with a managed FortiGate through FortiManager after upgrading the
FortiGate to v7.4.9 when a trusted host is configured. Scope FortiGate
v7.4.9. Solution The FortiGate is connect...
Description This article describes how to schedule fabric-upgrade
through CLI on FortiGate. Scope FortiGate. Solution CLI
configuration:Run the command below to initialize the fabric upgrade.
execute federated-upgrade initialize Preparing for federat...
Description This article describes how to configure the automation
stitch to reboot the managed FortiSwitch daily at a desired time. Scope
FortiGate. Solution Here are the CLI script to configure this automation
stitch for 1:00am specific time and da...
Hello Alex, For acme certificate port 443 and port 80 is going to be
used so if vip is configured for port 443 or 80 then all traffic is
going to dnat using vip which is going cause issue for acme. Not for all
VIP but with vip which is created using ...
Hello Jab, Have you configured ippool ip address as secondary ip address
on wan interface ? Can you please try to assigned ip address as
secondary ip address on interface and try to
ping.https://community.fortinet.com/t5/FortiGate/Technical-Tip-Set-a...
Hello Julian, It look correct configuration, as you have mention
ra-giaadr as loopback ip address so you will also get a ip according to
that scope. Also checked connectivity between loopback address to dhcp
server like ping from loopback to dhcp ser...
