Hello, I want to install an video conference by AVER that supports
H.323.I have made the port forwarding the user manual states (see below
photo) but it does not operate ok. i.e. although I can see and hear the
remote party, my camera and microphone ...
Hello, I am a beginner with Fortigate and i am trying to connect an
H.323 video conference system in my office in order to make conferences
with remote locations but since i will connect the system behind NAT, i
have to forward several ports to the v...
I actually did checked with the show command and saw that 2 and 3 were
deleted, I must have done it earlier in the morning while trying to find
out how to make the system operate. The 13 (sip) was still enabled but
even after deleting this and reboot...
Thank you very much for your help! :) I have done what the link
suggests, so i deleted 2 and 3 from the session helper but the problem
persists: The H.323 call is connected successfully BUT i can only see
and listen the remote caller, i cannot transm...
Thank you for your reply! i go to cli and put the following commands but
i get command fail errorconfig system settingsset sip-helper enable (or
disable) my firmware version is 6.4.8
Thank you very much for your feedback.I want to operate an SVC video
conference by Aver that supports H.323. I have made the port forwarding
the user manual states (see below photo) but it does not operate ok.
i.e. although I can see and hear the rem...
