We have 2 Fortigate 200F firewalls in HA.The WAN interface is responding
to ping from any ip address.We want to be able to ping this ip from
certain locations only so we added these ip addresses to trusted hosts
section under administrators. When I r...
We have 2 Fortigate 200F firewalls configured in an active active HA
cluster. We are on firmware version 7.0.6. At the moment I can connect
to the SSL VPN and browse to the mgmt UI which is always the active
firewall. We want to be able to connect to...
I have 2 Fortigate 200F firewalls configured in an active/active
cluster. Fail over between the firewalls seems to work fine but when I
reboot one firewall the WAN port seems to become disabled. When I
physically check the firewall I can see no light...
Hi Adrian, Thanks for the reply. We don't have any admin profiles
without trusted hosts. The local-in-policy is also not configured.
config system adminedit "xxxxxxxx"set trusthost1 x.x.x.x
255.255.255.255set trusthost2 x.x.x.x 255.255.255.255set tru...
We are not using VRRP. We have 2 cables coming into the rack which are
provided by our ISP. These are connected to a trunk port on each switch
(Dell N2024). Each switch is connected to a firewall via an access port
using VLAN id assigned by our ISP. ...
Hi Alif, Thanks for the reply. I will try this suggestion and let you
know how it goes. I was wondering if this is the recommended way to
configure WAN ports in an active-active environment? I had previously
configured the cluster as active-passive b...