You are leaving our website

AdrianR · 05-31-2024

Hello, I'm testing a configuration using aggregate dial-up IPsec but I'm having trouble getting it to work. The thing is that in the IPsec Tunnels configuration the aggregate "Test" shows up in green, but when I create the static route in Network -> ...

AdrianR · 10-06-2023

Hello everyone!I was wondering why is not possible to assign named address to SD-Wan, or I'm missing some option/configuration that enables it.For example:I have this static routesAnd I want them in a single static route with named address I'm using ...

AdrianR · 05-30-2023

Hello, I want to make a policy with Geo Blocking in my wan port that's inside an SD-Wan interface, I tried to configure the policy with income interface SD-Wan but it doesn’t work, If I take out my wan from the SD-Wan and configure the policy with in...

AdrianR · 06-05-2024

@Toshi_Esumi one more question, in the server side of your configuration does the static route detectes the aggregation as UP in green?

AdrianR · 06-03-2024

I tried with automatic route but is the same problem, its shows down in routing table

AdrianR · 06-03-2024

Hello @AEK I tried with automatic route but in the routing table it stills shows the aggregate as down although the aggregate is up in IP sec.

AdrianR · 06-03-2024

Hello @Toshi_Esumi sorry for the late response, here is the output, from the HUB side I don't have problemas the static route appears up (green)HUB-40F # get vpn ipsec tun sum'P1' 10.10.10.2:0 selectors(total,up): 1/1 rx(pkt,err): 2650/0 tx(pkt,err):...

AdrianR · 01-05-2024

You are correct, its not possible to add named addresses in version 7.0 although in version 7.2 the option is now available!

User Statistics

User Activity

Aggregate dial-up IPsec tunnel

Assign named address SD-WAN zone

Geo Blocking with SD-Wan enable

Re: Aggregate dial-up IPsec tunnel

Re: Aggregate dial-up IPsec tunnel

Re: Aggregate dial-up IPsec tunnel

Re: Aggregate dial-up IPsec tunnel

Re: Assign named address SD-WAN zone