Fortinet Community

smujeeb · 07-28-2022

Description This article describes how to get debugs for Tacacs+ authentication on FortiAuthenticator appliance. Scope FortiAuthenticator. Solution In the FortiAuthenticator Tacacs debugs, the configured realm is not shown instead it refers to readiu...

smujeeb · 06-30-2022

Description This article describes how to migrate an interface to an active SDWAN zone using the wizard. Manual process requires that all interface references to be removed for example, Firewall policies and routes. This is especially useful when the...

smujeeb · 06-21-2022

Description This article describes that tunnel fails to come up with 'Peer SA proposal not match local policy' message in logs. Scope FortiGate. Solution The VPN configuration is identical on both local and remote ends but the VPN still fails to come...

smujeeb · 06-21-2022

Description This article describes how to edit a VLAN ID for VLAN virtual interface after creation. Scope FortiGate. Solution Once a VLAN interface is created, it is not possible to edit the VLAN ID. The solution is to create a new interface with the...

smujeeb · 03-14-2022

Description This article describes that VRF is not supported for IPv6. Scope FortiOS versions below 7.0.x. Solution In FortiOS versions prior to 7.0.1, the IPv6 routing table does not show connected networks when VRF is enabled. Adjacencies for Dynam...

Fortinet Community

User Statistics

User Activity

Technical Tip: FortiAuthenticator Tacacs+ troubleshooting and debugs

Technical Tip: Migrate Physical Interface to SDWAN zone

Technical Tip: IPsec Not Match Local Policy

Technical Tip: Edit VLAN ID of a VLAN interface

VRF Support for IPv6

Technical Tip: IPsec Not Match Local Policy