Hi fellows: I have a fortigate 100D "G2" running 4mr3 patch 15, and a
new one G3 shipped with 5.2, the idea is to replace the G2 with the G3
hardware, and i am just wondering about downgrading the G3 to 4.3.15 in
order to execute the upgrade steps to...
Hi: I wonder what kind of hardware would you recommend in order to
support a 200 Mbps ipsec tunnel. It will be a single tunnel between 2
metropolitan locations, FTTH links with 200 upload / 200 downoad
capability, i have one of this links already, wi...
Hi: I´m planing to implemente HA virtual clustering, and as far as i can
read on the documentation, fortigate cluster uses a special set of mac
addresses on the interfaces, i have an scenario where i need to specify
a specific mac address on some int...
emnoc: I dont remember if the box says some thing about, don´t think so,
i will have access to the box in 10 days and tell you more, but i got 2
units, one in july and one in august, the first one was -05, the second
one -04, i´m talking about two di...
Thanks emnoc and ede_pfau. i´m a little embarased since most of the
times i read carefully the release notes, of course i missed it this
time i will do the upgrade to 5.0.14 first in prod, then copy config on
the newer one, and upgrade to 5.2.8 after...
Just want to update this thread My new FG100D, with part number
P11510-05 and by the way it comes with a Quad Core cpu, does not support
4MR3. It went to a kernel panic every try, with 4.3.15 and 4.3.18. It
was shipped with 5.2 but the older firmware...
