Technical Tip: How FortiGate perform TCP randomize...

psanjaykumar · 09-12-2022

Description This article describes the ways users can see the connected device Mac address for the Hardware/Software switch. Scope FortiGate. Solution Let’s consider a FortiGate which has a software switch configured as follows. config system switch-...

psanjaykumar · 08-12-2022

Description This article describes how FortiGate perform TCP randomized initial sequence number by default. Scope FortiGate. Solution It is possible to check this behavior by taking packet capture at ingress and egress interface of FortiGate. If flow...

psanjaykumar · 07-15-2022

Description This article describes how to add a new DHCP addressing mode wan connection as a redundant connection without affecting the primary connection. When trying to add a new redundant DHCP addressing mode wan connection to an existing primary ...

psanjaykumar · 02-20-2022

Description Virtual VLAN switch builds on the Hardware Switch mode, by allowing vlan tagging to be configured and the configuration of trunk interface(s). The ports that can participate in these vlans and trunk(s) are limited to the Hardware Switch p...

psanjaykumar · 02-20-2022

# config system global # set virtual-switch-vlan disable # end

User Statistics

User Activity

Technical Tip: How to track associated mac address connected with member port of FortiGate Hardware/Software switch

Technical Tip: How FortiGate perform TCP randomized Initial Sequence Number by default

Technical Tip: Adding new DHCP addressing mode wan connection for redundant traffic flow without bringing down the network

Technical Tips : FortiGate Does not show the Hardware switch option in GUI

FortiGate Does not show the Hardware switch option in GUI

Technical Tip: How FortiGate perform TCP randomize...

KCS