Dear team, I noticed that Cisco Switch are not accept Radius
CoA/Disconnect Message from FortiNAC-F 7.4. I'm not sure if we need to
have any customer RADIUS Attribute to pass to the Cisco Switch. I would
like to share debug of pcap and Switch here.An...
Dear Team,We have FortiNAC using as local RADIUS for our Cisco Switch.
We have Endpoint Access Policy with using RADIUS RFC Vlan for changing
User VLAN based on Access Policy. We have Endpoint Compliance to move
user to Non-Compliant VLAN and mark at...
Dear Team, We have Endpoint authenticated via FortiNAC via RADIUS Local.
Endpoint has Persistent Agent installed. Our purpose is to give endpoint
access when their PC is compliant but we noticed that endpoint shown
OFFLINE on FortiNAC after around 30...
Dear Team, I would like to any possible way or guide for configuring
FortiSIEM to send notification via Telegram or Microsoft team.
Appreciate for every answer. Thank You
Dear @Hatibi , My host is at risk (+) and It matched to new
non-compliant policy. For Polling, If you refer to L2 or RADIUS, I can
say it is enabled and working.For RADIUS Accounting, It is configured
and i also see accounting traffic. Thank You
The same as mine. It always mark host Offline when host is still online
and their Persistent Agent is active. I should have other way to ensure
that host is offline but i'm not sure
