Description This article describes the issue of FortiGate SD-WAN
Performance SLA not being available on the FortiPortal device list
screen after upgrading from v7.2 to v7.4.5. The article provides a
step-by-step solution to troubleshoot and resolve t...
Description This article describes the process of updating firewall
configurations to include new Intune network endpoints as part of
Microsoft's Secure Future Initiative. It provides a step-by-step guide
on how to add the AzureFrontDoor.Microsoft Se...
Description This article describes a scenario where the SD-WAN SLA probe
fails due to the route bypassing the tunnel and going through the
HUB-VPN instead, and how to troubleshoot and resolve the issue. Scope
FortiGate. Solution To troubleshoot the i...
Description This article describes how to resolve the FortiClient EMS
internal error caused by a DNS resolution issue. The error occurs when
the endpoint fails to connect to the FortiClient EMS server due to a DNS
resolution failure. Scope FortiClien...
Description This article describes the steps to troubleshoot and resolve
page timeouts and session timeouts on FortiGate with transparent proxy.
The issue is observed when the FortiGate is configured with transparent
proxy and the traffic is forwarde...
Hi Rouzbeha, Pls review the below doc and see if this helps.
https://docs.fortinet.com/document/fortiswitch/7.4.5/fortilink-guide/801184/viewing-and-upgrading-the-fortiswitch-firmware-version
Try to execute the command in FortiGate and try again. con...
Hi John, Thanks for your response. It seems like we need to deep dive
into this. I would suggest reaching out to the support team via
https://www.fortinet.com/support/contact and leveraging the webchat to
create a new case or logging in to your Forti...
Hi John, The group configuration is not necessary if you are testing
with a single user. As you have confirmed that the configs looks intact
and you have received the 2FA, consider adjusting the remote auth timer
as below: config system global set re...
Hi, The behaviour you are experiencing is consistent with the design.
When a ZTNA tag is removed, existing sessions that were established
while the tag was valid will remain active until they expire or are
manually cleared. This is by design to preve...
Hi Franklin, You may review the items below to see if this fix your
issue: For Fibre link: - Enable FortiLink P2P on the ports connected to
the fiber link on both FortiSwitch units. - Ensure the TPID value is
consistent on both ends. config switch ph...