Description This article describes how to fix the issue with the
Approval step or any other step in the playbook that shows deprecated.
Scope FortiSOAR, Solution Problem statement: The 'Approval' step in the
playbook module shows deprecated and a war...
Description This article describes how to fix internal server errors in
FortiSOAR that occur due to SSL cert expiry. Scope FrotiSOAR 7.2.0 and
above. Solution Users may experience internal server errors while
accessing the FortiSOAR Application at mu...
Description This article describes how to fix the issue of dependencies
for the Vmware Carbon black connector. Scope FortiSOAR 7.4 and VMware
Carbon Black EDR connector 2.0.2. Solution Users may sometimes
experience the following error when attemptin...
Description This article will help fix an issue where a schedule
triggers multiple times, even if the 'Limit execution to one active
instance at a time' option is enabled. Scope FortiSOAR. Solution The
'Limit execution to one active instance at a tim...
Description This article describes how to fix the 401 HMAC
authentication error when using the Splunk Add-on to create records in
FortiSOAR. Scope FortiSOAR. Solution When attempting to create an alert
in FortiSOAR using the Splunk Add-On, it consist...
Hello Adem, It should be an LVM type of partition. If there is available
disk space in the Volume Group (VG), the Logical Volume (LV) can be
extended directly. However, if there is insufficient space, you may need
to add a new partition, convert it t...
Hello @ranjeet Please refer to the below KB, might help in your case as
well.
https://community.fortinet.com/t5/FortiSOAR-Knowledge-Base/Troubleshooting-Tip-Unable-to-create-Alert-records-fails-with/ta-p/279408
Hello @khanchand Thank you for reaching out. You can use the same URL as
shared in the connector guide. This is a complete URL that needs to be
submitted in the browser after replacing the tenant and client ID. It
will return a different URL, use the...
Hello Awni, Kindly refer to the section "Installing or importing and
configuring a connector in FortiSOAR" in the below guide.
https://docs.fortinet.com/document/fortisoar/7.4.1/connectors-guide/929681/introduction-to-connectors
Regards, Ankit Jain
Hello, Could you please test the connectivity via the curl command, does
it shows connected #curl -v https://productapi.fortinet.com If not then
please verify this is allowed in the firewall & Proxy.