Re: iOS IPSec Questions Mobile (iPhone)

pdelapena · 11-26-2024

Description This article describes the cause of the error 'Duplicate entry found.' when creating or editing SDWAN rules via GUI and how this can be resolved. Scope FortiGate. Solution It is possible to create SD-WAN rules via the CLI without naming t...

pdelapena · 10-29-2024

Description This article describes how to properly group Internet Service Objects based on their direction and organize them into Internet Service Groups. Scope FortiGate. Solution Creating an Internet Service Group simplifies creation of FortiGate p...

pdelapena · 10-29-2024

Description This article describes using the alertconsole command in CLI to determine the historic date/time when a FortiGate was upgraded. Scope FortiGate. Solution It is important to verify the exact date/time when was the firewall upgraded, especi...

pdelapena · 10-16-2024

Description This article describes how to create an administrator profile with least-privileges that can be assigned to an administrator who can run the command 'execute factory-reset' for the device. Scope FortiGate. Solution If the FortiGate needs ...

pdelapena · 09-15-2024

Description This article describes the port conflict issue when the same port number 8080 is used for Explicit Web Proxy HTTP incoming port and HTTP Administrative Access port. Scope FortiGate. Solution If Explicit Web Proxy is enabled even if not fu...

pdelapena · 09-14-2024

Hi everyone,Just to supplement this information, it is now possible in FOS v7.4.4+ or v7.6.0+ to use IP Reputation Database Objects as Source Address in the Local-in Policy. You may refer to this guide : https://community.fortinet.com/t5/FortiGate/Te...

pdelapena · 07-21-2024

Hi @roni_lucas ,Your inquiry best fits this guide below which talks about the effect of increasing the number of characters in your VPN name :- https://community.fortinet.com/t5/Blogs/IPSec-Remote-Access-VPN-Naming-Limitations-on-FortiGate/ba-p/23846...

pdelapena · 07-15-2024

Hi @Si600 ,If you have configured DoS policies, have you tried checking your Anomaly logs? That should give some information where the udp_flood attacks are coming from.Regards,

pdelapena · 07-15-2024

Hi @Sivasakthi ,You can opt to set up your FortiGate as a Dial-Up client. Refer to the guide below.https://docs.fortinet.com/document/fortigate/7.4.4/administration-guide/6896/fortigate-as-dialup-clientRegards,

pdelapena · 07-15-2024

Hi @FawziHafedh @ ,Please try to check if you have provisioned an incorrect VM image. In the output of "get system status" try to see if the what's stated in the version is "FortiFirewall-VM64-KVM".Use the "FGT_VM64_KVM" image instead. Download the c...

User Statistics

User Activity

Troubleshooting Tip: Unable to create or edit SD-WAN rules in the GUI due to the error 'Duplicate entry found.'

Technical Tip: Internet Service Grouping in relation to direction

Technical Tip: Verifying FortiGate Upgrade History using alertconsole command

Technical Tip: Least-Privilege Administrator Profile to Factory-Reset the FortiGate

Troubleshooting Tip: Port conflict issue between Explicit Web Proxy HTTP incoming port and HTTP Administrative Access port

Re: Fortinet recommended malicious IPs or URLs, or Malware Hash source

Re: Phase2 values Fortigate 300E

Re: Built-in Threat Report Analysis

Re: If WAN interfaces are in DHCP mode How shall i configure IPsec tunnel Remote address

Re: Eve-ng Fortigate VM ccnnot install trial licence

Re: iOS IPSec Questions Mobile (iPhone)

Troubleshooting Tip: SFTP configuration backup iss...

Re: Built-in Threat Report Analysis

Re: Can't setup a VPN user.

Re: How to solve DNS resolution in android and iOS...

KCS