Description This article discusses Virtual Server Load Balancer's
behavior when using IP-based load-balancing on Active-Passive Real
servers. Scope FortiGate. Solution The original behavior for a
server-load-balance VIP that has both active and stand...
Description This article describes that FortiGate HA shows out of sync
after upgrading to 7.2.4 build 1396 due to a checksum mismatch for
endpoint-control.fctems. Scope FortiGate v7.2.4. Solution A new feature
and a CLI toggle of 'set trust-ca-cn' wa...
Description This article describes an issue where a virtual server stops
working after upgrading to FortiOS v7.2.4 build 1396 and offers a
workaround. Scope FortiGate v7.2.4 and later. Solution Virtual server
configuration fails to work when multiple...
Description This article describes an issue where packet drop on an
IPsec tunnel interface shows the message 'no route to ,
drop' in the debug flow. Scope FortiGate. Solution When an IPSec tunnel
is configured on an interface (i.e. VLAN interface, Ph...
Description This article describes how to authenticate wireless users
using their MAC address and their Active Directory credentials. Scope
FortiGate, FortiAP. Solution This article is to demonstrate how to
perform Authentication of Wireless clients ...
Hi, Thanks for confirming that it's working. RCA has been publicly
published:
https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-Virtual-server-stops-working-after-upgrading/ta-p/246189
Regards, Parassingh
Hi, Please try to disable http2 as a workaround and test if it works.
It's configured under #config firewall vip. A snippet from my lab for
example: config firewall vip edit "Virtual Server" set uuid
59acd588-ac9b-51ed-8251-b880c505cedd set type serv...