Troubleshooting Tip: IPsec Wizard Next button is g...

chanm · 11-17-2025

Description This article describes a known issue and workaround where, after upgrading FortiGate 4xF/6xF series to FortiOS v7.6.4, IPsec traffic fails when the IPsec tunnel is up. Scope FortiGate 4xF/6xF, FortiOS v7.6.4. Solution This issue affects b...

chanm · 08-11-2024

Description This article describes how to retrieve all IP addresses associated with an address group in the CLI. Scope All FortiOS versions. Solution When there are many address objects in an address group, it can be difficult to get the full list of...

chanm · 06-13-2024

Description This article describes how to work around the error 'SAML user number is more than one' when adding multiple SAML groups into a firewall policy. Scope Any FortiOS firmware with SAML support. Solution FortiOS only allows SAML groups that a...

chanm · 11-16-2023

Description This article describes how to resolve the issue where, after using an Easy Configuration key to configure a spoke FortiGate through the IPsec Wizard, the Next button on the Policy & Routing page is greyed out and the IPsec Wizard will not...

chanm · 07-16-2023

Description This article describes how to work around the issue where, after a firmware upgrade to FortiOS 7.0.12 or 7.2.5, the Network -> SD-WAN -> SD-WAN Zone and Network -> SD-WAN -> SD-WAN Rules GUI pages get stuck loading. The Network -> SD-WAN ...

User Statistics

User Activity

Troubleshooting Tip: IPsec tunnel intermittently stops passing traffic after upgrading FortiGate 4xF/6xF series to FortiOS v7.6.4 (Known Issue)

Technical Tip: Retrieve IP addresses of all member address objects in address group in text-based format

Troubleshooting Tip: Error 'SAML user number is more than one' when adding multiple SAML groups into firewall policy