Hi all, I like to know is there possibility to keep VPN IPSec tunnels up
when linked to backup interface (WAN2) and backup ISP.I got FGT60E with
WAN1 (1 ISP) and WAN2 (2 ISP - backup), to WAN1 got connected IPSec
Tunnel to another FGT, and on WAN2 go...
Hi all, got one question about downgrade and recovery after failed
update in HA cluster (A-P).When update failed and need to downgrade and
upload configuration once again the best way for this is to:1.
disconnect slave from HA,2. downgrade firmware a...
Hello, I notice in Security Fabric\Fabric Connectors in Core Network
Security I'm missing Security Fabric Setup tab.I'm not sure why is that.
In other Fortigates FGT60E and FGT60F it is and can configure it without
no problem.Was checking Global and ...
Hi,sometimes when my EMS not sync with AD (minimum interval in EMS is 60
minutes) and I install on new computer FCT connected to EMS, FCT is
assigned to Workgroup instead in Domain Group.I know it is because new
record (of computer) in AD not sync wi...
Hi, recently I made update of my FortiGate's 60E working in HA.I notice
after update has changed MAC address of Hardware switch, Internal1 where
got connected all VLANs, from something like xx:xx:xx:09:00:12 to
xx:xx:xx:09:00:03.Is it normal, or I mi...
Hey Debbie_FTNT, thanks for your response,this also not the case, I got
connected EMS thru Security Fabric like You say.But now want to enabled
SAML SSO in EMS and to do it need to enabled it in FGT Security Fabric
Setup, and that is what I missing, ...
Thank you for your replay! FGT 500E is not managed through FortiManager
but this is not the case.Reason I need to configure Security Fabric
Setup is because need to check/turn on SAML SSO on my FortiClientEMS.So
basicly need Security Fabric Setup tab...
Toshi_Esumi thanks for all your efort. Analyzing debug flow, starting to
check why it is droping on policy and find this post: