Technical Tip: Traffic getting dropped due to Mult...

ekrishnan · 11-24-2025

Description This article explains the complete configuration required for SSL VPN split tunneling to work. Scope FortiGate. Solution The setup will involve the following configurations: Enable SSL VPN. Security policy (Firewall policy). SSL Inspectio...

ekrishnan · 11-18-2025

Description This article describes the possible cause for the LDAP error: 'Password verification failed(80090308: LdapErr: DSID-0C090598, comment: AcceptSecurityContext error, data 52e, v4f7c).'. Scope FortiPAM. Solution It is observed when trying to...

ekrishnan · 07-08-2025

Description This article explains the difference between Google Drive and Google Drive file upload logs. Scope FortiGate. Solution When a file is uploaded to Google Drive, the application name will be shown as 'google.drive_upload' along with file na...

ekrishnan · 07-07-2025

Description This article explains the changes in the CLI parameters for PKI user settings starting from v7.4.1 used for validation against the LDAP server. Scope FortiGate. Solution Up to v7.4.0: config user peer set ldap-mode [password|principal-nam...

ekrishnan · 06-07-2025

Description This article explains how to change the default UDP port 1646 for RADIUS account monitor to a different port. Scope FortiAuthenticator. Solution Navigate to Authentication -> RADIUS Service -> Services. Example: The port number is changed...

ekrishnan · 02-26-2024

Hi, You will have to disable NPU offloading in the firewall policy which is allowing this traffic in order to see a full capture. >>Further a deep analysis should be done on the capture taken on the receiving end to observe what happens before the Ke...

ekrishnan · 12-14-2023

Hello, Managed Switches which is shown on the FGT is only for Fortiswitches and non-fortinet switches will not be shown here. However you can use the Device inventory to see if other switches are detected but again you cannot manage or monitor it lik...

ekrishnan · 12-14-2023

Hello, Based on the query I believe the second policy with ISDB gets the hit because these are predefined services in the ISDB. whereas For wildcard FQDN addresses to work, the FortiGate should allow DNS traffic to pass through. Initially, the wildca...

ekrishnan · 12-04-2023

Hello @rezafathi , Yes on versions 7.4.1 this feature has been enhanced. Please find the reference link below for clarification, https://community.fortinet.com/t5/FortiGate/Technical-Tip-Maximize-SLA-Bandwidth-Load-Balancing-in-version-7/ta-p/287419 ...

ekrishnan · 11-08-2023

Hi, I believe this is a change in newer version and either you need to choose access NONE for the system config to achieve your goal, I am afraid no other way can be seen as the Feature visibility is tagged under the system config on the current vers...

User Statistics

User Activity

Technical Tip: Configuration of SSL VPN split-tunneling in Central SNAT FortiGate

Technical Tip: LDAP error when trying to verify password

Technical Tip: Identifying and differentiating the logs for Google Drive and Google Drive file upload

Technical Tip: Modified CLI parameters for 'PKI' user setting and associated LDAP configuration from firmware v7.4.1

Technical Tip: Custom UDP port configuration for RADIUS account monitor in FortiAuthenticator

Re: Firewall not sending Keepalive packet

Re: Having none Fortinet switches in Managed Fortiswitch Topology

Re: Firewall Policy - FQDN vs Internet Service

Re: maximized Bandwidth in SDWAN

Re: About vdom user configuration backup permission

Technical Tip: Traffic getting dropped due to Mult...

Technical Tip: Special/Reserved VLAN IDs on the Fo...

Technical Tip: Configuration of FortiAuthenticator...

Technical Tip: Checking VOIP traffic flow using Wi...

Technical Tip: Redundant IPSEC Tunnel using single...

Re: maximized Bandwidth in SDWAN

KCS

User Statistics

User Activity

You are leaving our website