I' m trying to figure out what causes any streaming videos to download
completely before playing. Example, we have a couple corporate videos
that we use for employment recuiting, about us and other corporate
related topics. The problem is that when y...
I have a mail server that is using a VIP inbound from Wan1 to Internal
IP mappped port to port for mail ports only. Ex. Wan1 10.90.90.9 to
Internal 10.10.10.210 The problem i have is that when the traffic goes
outbound from the server it is not using...
I got our new 100C using v4.0,build0138 (MR1 Patch 5) up and running but
i have a issue with the VM Fortiguard Service. In the License
Information Section the Vulnerability Management is showing as " Not
Registered" even thou i updated our support ac...
I' m in the process of upgrading too 2 x 200B' s in HA mode from a 200A
just waiting on the new appliance' s to arrive. Has anyone successfully
done a upgrade like this using the config from the 200A and bringing it
into the 200B' s? I know i will ha...
Is it just me or does v4.0,build0279,100519 (MR2 Patch 1) not properly
show what over rides are enabled for a catagory by IP in Webfiltering
Administrative overrides. What' s happeing is that when i create a
override for a IP and enable it, then go b...
ORIGINAL: BWiebe Had some strangeness with one firewall I upgraded, a
200B. The smbcd process was taking 30-40% of the memory on the device
and putting it dangerously close to conserve mode. After killing the
process, it seemed better, but eventually...
Same issue here also, it seems that they removed the administrator
overside via IP. This was and is a very important feature as we had
specific rules for internal ip' s to override certain catagories now you
have to do it via CLI it seems. It seems t...
I had the same problem on a 200B on wednesday that went unresponsive to
all traffic and responses. I consoled in with a cable and it was
erroring out with the following below error. Actually once i got in it
that only lasted for about 2 minutes befor...
We went from a 200A to two 200B' s in HA mode and we have never looked
back. We were even able to move our 200A config over to the 200B' s by
only exporting the config and using a text editor to change the port
names from the 200a to match the ones o...
Not sure how or why but a hour after this post it came up and showed
registered. Almost 48 hours exactly after i registered the license,
actually with in 4 minutes of the time stamp that i did it... So
strange.