Description This article describes how to enable the 'reply-to' if using
FortiOS 7.0.8 and above. Scope FortiOS 7.0.8 and above. Solution The
command 'set reply-to' used to be available by default: Since FortiOS
6.4.10 and 7.0.8, when the default 'no...
Description This article describes the additional configuration needed
when the route check-in SD-WAN rules are disabled Scope FortiGate.
Solution By default, each SD-WAN rule is expected to have a matching
route in the routing table, as the SD-WAN r...
Description This article explains how to work around lack of support for
Route leaking for the default VRF 0. Scope FortiGate/FortiOS 7.0.6 and
FortiOS 7.2.1. Solution Route leaking between default VRF 0 and other
VRFs is currently not supported. To ...
Description This article describes how to fix the 'Max Session Reached'
message. Scope FSSO Solution One of the reasons the FSSO users'
information is not being sent to FortiGate or the Monitored DCs list is
empty, could be due to the message 'Max Se...
Description This article describes how to set up the Fortigate as a L2TP
client. Scope Solution The FortiGate can be set up as a L2TP client only
through CLI as per below: # config system interface edit "wan" set
status up set l2tp-client enable < ne...