DescriptionThis article describes how to change FortiSwitch interface
mac-addresses by using the following instructions.SolutionLogin into the
switch interface and change the mac-address of the required
interface.FSW # config system interfaceFSW (int...
Description This article describes how to use Remote sampling on
FortiSwitch to capture packets specific to port, Mac-addresses or IP.
Scope For FortiSwitch managed by FortiGate.Solution In the below
example, all traffic is sent on Port 1 to destinat...
DescriptionThis article describes how to enable logs for specific
filters.Solution1) Generally, logs can be viewed from from FortiSwitch
using '# execute log display'.FSW # execute log display596 logs found. 1
logs returned.1: 2020-12-16 18:01:42 log...
DescriptionIn some rare scenarios, if FortiSwitch upgrade fails via GUI
and CLI, upgrade the via boot sequence is possible.This article
describes how to upgrade a FortiSwitch via the boot sequence.Solution1)
Plug in the console cable to the Fortiswit...
DescriptionThis article describes how to generate a CSR and to map the
new certificate to Standalone Fortiswitch from GUI.SolutionIn
Fortiswitch, importing new SSL certificate and using it for the GUI or
802.1x authentication is possible.- Go to Syst...
Dear @blake09 Hope you are doing well. Normally for a managed
fortiswitch, when any vlan is created under "Fortiswitch vlan" section,
it will get pushed to the switch. In managed Fortiswitch scenario , the
switches act as layer-2 , while the gateway ...
Dear @OmarMuhumayev Hope you are doing well. Can you please ensure the
following LLDP med voice profile/config is configured correctly on the
fortiswitch port . Referenced Article :
https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/939493/v...
Dear @nrahman Yes with switches more than two switches, we can have
first two core switches directly plugged into the FSW . Configure
stacking b/w them (mclag-icl) and connect end switches on the core .
Example architecture : Multi-tiered MCLAG with ...
Dear @nrahman It depends on how many and the model of switches . I would
recommend an "mclag-icl" setup per the topology guide(supported for 1xx
series above) :
https://docs.fortinet.com/document/fortiswitch/6.4.2/devices-managed-by-fortios/617516/ne...