Fortinet Community

vdralio · 08-26-2021

DescriptionThis article describes how to configure IPsec with mode-config and DHCP using the gateway IP.For an IPsec tunnel, the gateway IP address (giaddr) can be defined on a DHCP relay agent. Both IPv4 and IPv6 addresses are supported. An IPsec tu...

vdralio · 05-20-2021

DescriptionThis article describes the way to use FortiToken in multiple units (Not recommended in production).Basically, It is advised to try it in a test/lab environment.SolutionFortiToken are different types and not all of them can be used on multi...

vdralio · 03-07-2021

DescriptionThis article describes how to adjust Hard FortiTokens for clock drift when used as Two Factor Authentication for VPN connections (SSL VPN and/or IPsec VPN).If a user experiences clock drift, it may be the result of incorrect time settings ...

vdralio · 10-31-2020

DescriptionThis article describes how to trace the inspection mode based on session flags.SolutionSession flags indicate the traffic is inspected in flow based mode or proxy based mode.# Flag ndr means the traffic is inspected in flow based mode. Add...

vdralio · 09-21-2020

DescriptionThis article describes how to allow one dialup IPsec VPN client to communicate with another dialup IPsec VPN client.SolutionRequirement to allow communication between two dialup IPsec clients is rare. In that scenario, achieve it by follow...

vdralio · 09-21-2022

Dear @zoah666 , Please find the article below for more information: https://community.fortinet.com/t5/FortiClient/Technical-Tip-FortiClient-licensing-and-support/ta-p/196327?externalID=FD48147 Best Regards, Vasil

vdralio · 09-12-2022

Dear @VinceMoon , You can create Custom Reports from FortiAnalyzer, FortiGate is limited on this one. Please check below the article: https://community.fortinet.com/t5/FortiAnalyzer/Technical-Tip-How-to-build-a-custom-report-on-FortiAnalyzer/ta-p/196...

vdralio · 09-12-2022

Dear @JawadEA , Please find below the article that answers your question: https://docs.fortinet.com/document/fortigate/6.0.0/handbook/784981/vlan-switching-and-routing Best Regards, Vasil Dralio

vdralio · 09-12-2022

Dear @warbkhelo , Please find below the datasheet for FGT 60D you can check there the values Please find below details with regards to the end of support for the FGT-60D device and you can find the same details on support.fortinet.com under Product L...

vdralio · 09-12-2022

Dear @urushi , Configuring SSLVPN with FortiGate and FortiClient is pretty straightforward. Nevertheless, problems may occur while establishing or using the SSLVPN connection. If the negotiation of SSLVPN stops at a specific percentage: 10% – there i...

Fortinet Community

User Statistics

User Activity

Technical Tip: IPsec IKEv2 with mode-config and DHCP using the gateway IP address

Technical Tip: How to use FortiToken for multiple units

Technical Tip: Hard FortiToken clock drift adjustment

Technical Tip: Session flags and inspection mode

Technical Tip: Enable communication between dialup IPsec VPN clients

Re: Which FortiClient license to buy only for VPN + tech support?

Re: Reporting on which users visited a specific URL

Re: Inter Vlan Routing on a Fortigate

Re: Question about Fortigate FG60D...

Re: Forticlient VPN stuck at 10%

Re: HELP! Fortitoken issues.

Re: Fortigate-HA Update FortiGuard via Mgmt port

Re: Port used by Fortiguard auth-port-warning?

Re: Tool to know how many users in total a FortiGa...

Re: Cannot delete VDOM due to tunnel interfaces

Re: Port used by Fortiguard auth-port-warning?

Re: Tool to know how many users in total a FortiGa...

Re: Cannot delete VDOM due to tunnel interfaces

Re: Remote SSL VPN User cannot see other branches.

Re: How to position right Fortigate model for 3000...