Fortinet Community

sselvam · 11-04-2020

DescriptionThis article provides a sample of firewall policy views. SolutionPolicy views.- In Policy & Objects policy list page, there are two policy views: 'Interface Pair View' and by 'Sequence view'.- 'Interface Pair View' displays the policies in...

sselvam · 11-04-2020

DescriptionThis article provides a sample of firewall policy lookups.SolutionPolicy lookups.- Firewall policy lookup is based on the Source_interfaces/Protocol/Source_Address/Destination_Address that matches the source-port and dst-port of the protoc...

sselvam · 10-22-2020

DescriptionThis article describes how to configure MAC-based 802.1X authentication to managed FortiSwitch ports when using FortiLink.SolutionManaged FortiSwitch will authenticate and record the MAC addresses of user units. If there is a hub after the...

sselvam · 05-27-2020

DescriptionThis article describes how to learn policy in IPv4 policy.SolutionWhen installing a new FortiGate, the first policy set up is usually one that goes from the inside to the Internet with fairly little in the way of restrictions. After all, m...

sselvam · 05-26-2020

DescriptionThis article provides information about the dynamic gateway for DHCP/PPPoE type interfaces.SolutionTo route both to be active with static route on the routing-table, enable the below option from the CLI:First, set the interface to not get ...

Fortinet Community

User Statistics

User Activity

Technical Tip: Firewall policy views

Technical Tip: Firewall policy lookups

Technical Tip: MAC-based 802.1X authentication

Technical Tip: Learning policy in IPv4 policy

Technical Tip: Static route for DHCP/PPPoE interfaces with dynamic gateway

Technical Tip: How to find the interface's MAC add...