Description This article describes how to connect the Guest VLAN users
to SSL VPN configured on the WAN port. Scope FortiOS Solution In some
cases, Guest VLAN users have restricted Internet access when connected
through the Fortigate. If the user nee...
Description This article describes the issue while implementing SSL VPN
initial configuration from the GUI, where a warning 'Port conflicts with
the administrative HTTPS port for this system' appears. This occurs
because FortiOS is configured to use ...
Description This article describes the case when implementing SSL-VPN
initial configuration from the GUI, the error 'Please set the default
portal for all other users/groups in the authentication/portal mapping'
appears. This happens because no porta...
Description This article describes how to manually perform a firmware
upgrade from GUI and CLI. Scope From FortiGate v7.2 and above.Solution
FortiGate administrator access is required with Read and Write
permission. The recent firmware build from the...
Description This article describes how to configure the DoS (Denial Of
Service) policy on FortiGate. Scope FortiGate.Solution To configure the
DoS policy on the GUI, make sure 'DoS Policy' is enabled under System ->
Feature Visibility: Configure DoS ...
I don't think we have any option on Foritgate firewall to achieve this
requirement . Usually , the forwarding decision is taken on the source
host with an and operation then it sends the packet to gateway ip when
the destination host is out of it's o...
Yes , policy route should be ignored if the selected gateway interface
state is down so the lookup will happen to the next policy route in list
. Apart from this , you have option of SD-WAN or Link-monitor which can
be implemented to monitor the link...