Technical Tip: FortiLink P2P supported network top...

riteshpv · 04-18-2024

Description This article describes the reasons behind throughput issues in the 1xx series FortiSwitch and provides potential solutions. Scope FortiSwitch models F1xxE and FS1xxF. Solution Consider 4 PC connected to a Fortiswitch. PC1, PC2 on vlan1 an...

riteshpv · 03-29-2024

Description The article describes how to evaluate FortiSwitch PSU status and Alarm LED behavior when PSUs are disconnected or fail. Scope Standalone/Managed FortiSwitch with dual PSU. Solution FortiSwitch Front panel: The alarm led is available on th...

riteshpv · 12-27-2023

Description This article describes possible reasons for an inability to configure a setup with 4x10G using a 100G QSFP28 and offers solutions. Scope FortiSwitch T1024E , FortiSwitch 1024E v7.4.2. Solution The T1024E/FS-1024E has ports 25 and port 26 ...

riteshpv · 09-22-2023

Description This article describes why just 8 FortiSwitches can be managed by a FortiGate and how to solve it. Scope FortiSwitch v6.4.x and above. Solution The topology connection is as follows: Note. Here the Fortiswitch1 is a 100 series FortiSwitch...

riteshpv · 11-29-2022

Description This article describes how to process if FortiSwitches are unable to ping each other on the same VLAN when the VLAN is allowed between the switches. Scope FortiSwitch v6.4.x / v 7.0.x / 7.2.x Solution One of the possible causes of this be...

riteshpv · 11-13-2023

Hi Jacky, Disable dhcp-snooping if enabled on vlans. If you still see issue then provide the following logs in the TAC ticket with FSW serial no. show full-configuration diagnose switch pdu-counters listdiagnose debug crashlog readdiag debug report R...

riteshpv · 10-23-2022

Hi, Verify if you are using the recommended compatible transreceiver: https://fortinetweb.s3.amazonaws.com/docs.fortinet.com/v2/attachments/e867c8f4-202f-11e9-b6f6-f8bc1258b856/FortiSwitch-Compatible-Transceivers.pdf If you still seeing issue then on...

riteshpv · 05-10-2022

No.The vlan config can be pushed from FGT to managed FSW but that vlan is local to the network and FGT cannot be gateway for these vlans.

riteshpv · 03-15-2022

Hi Fortime, I hope this is what you are trying to achieve. FSW managed over L3. https://docs.fortinet.com/document/fortiswitch/7.0.4/devices-managed-by-fortios/801182/fortilink-mode-over-a-layer-3-network Once managed the L3 FSW will automatically cr...

User Statistics

User Activity

Troubleshooting Tip: Throughput issue when traffic flows between 2 VLANs

Technical Tip: Alarm led status does not change with PSU disconnection

Troubleshooting Tip: Unable to configure speed 4x10G manually on FS-T1024E/FS-1024E.

Technical Tip: Cannot get more than 8 FortiSwitches managed on a FortiGate

Technical Tip: Unable to ping/SSH between direct connected FortiSwitch on same VLAN

Re: FortiSwitch FS-108F got CPU_SENSOR warning event and Memory high usage and System high temperatu

Re: SFP+ resets every 3 minutes

Re: conventional fortilink or fortilink over Layer3?

Re: conventional fortilink or fortilink over Layer3?

Technical Tip: FortiLink P2P supported network top...

Technical Tip: Explanation on values of 'auto-isl....

Technical Tip: Cannot get more than 8 FortiSwitche...

Technical Tip: Unable to ping/SSH between direct c...

Technical Tip: HTTPS access to managed FortiSwitch

Fortinet Training Institute

KCS