Description This article describes the steps to push configurations or
execute commands on all managed FortiSwitch devices simultaneously.
Scope FortiGate v7.4 and FortiSwitch v7.4 Solution Procedure to Push
Configurations to All Managed FortiSwitch ...
Description This article describes an issue observed with the
FortiSwitch 6XXF series running FortiSwitchOS version 7.4.3. Scope
FortiSwitch 6XXF on FortiSwitchOS v7.4.3. Solution Behavior: The issue
is primarily encountered during the following scen...
Description This article describes an issue encountered where
configuration changes fail to push to a managed FortiSwitch after
changing the HTTPS port on the FortiSwitch. Scope FortiSwitch version
v7.2 v7.4 v7.6. Solution Basic Understanding: FortiS...
Description This article addresses issues that arise when a Virtual IP
(vrip) configured under VRRP shares the same subnet as the secondary IP.
Scope FortiSwitch v7.2, v7.4. Solution Below is an example of the VRRP
configuration on an SVI: config sys...
Description This article describes how to download and upload the
configuration on a FortiSwitch using FTP/TFTP through CLI commands, with
a PC connected to the FortiSwitch's management port. Scope Fortiswitch
v7.2, v7.4. Solution Topology: In this e...
Hi, I understand you have 300 standalone FortiSwitches that you’d like
to transition to a managed configuration using FortiSwitch Manager. If
that’s the case, these FortiSwitches will need to be manually configured
to enable management by FortiSwitch...
Hi Jacky, Disable dhcp-snooping if enabled on vlans. If you still see
issue then provide the following logs in the TAC ticket with FSW serial
no. show full-configuration diagnose switch pdu-counters listdiagnose
debug crashlog readdiag debug report R...
Hi, Verify if you are using the recommended compatible transreceiver:
https://fortinetweb.s3.amazonaws.com/docs.fortinet.com/v2/attachments/e867c8f4-202f-11e9-b6f6-f8bc1258b856/FortiSwitch-Compatible-Transceivers.pdf
If you still seeing issue then on...
Hi Fortime, I hope this is what you are trying to achieve. FSW managed
over L3.
https://docs.fortinet.com/document/fortiswitch/7.0.4/devices-managed-by-fortios/801182/fortilink-mode-over-a-layer-3-network
Once managed the L3 FSW will automatically cr...