Technical Tip: 'Device detection' changes

jvaishnav · 11-17-2020

DescriptionThis article describes IPSec Configuration in HA environment.ScopeFor version 6.4.3.SolutionThis is a sample configuration of site-to-site IPsec VPN in an HA environment.For this example, set up HA as described in the HA topics. When setti...

jvaishnav · 11-10-2020

Description This article describes OSPF with IPsec VPN for redundancy.Scope For version 6.4.3.Solution This is a sample configuration of using OSPF with IPsec VPN to set up network redundancy. Route selection is based on OSPF cost calculation. Config...

jvaishnav · 11-10-2020

DescriptionThis article describes the configuration of UDP hole Punching for spokes.ScopeFor version 6.4.3.SolutionUDP hole punching allows ADVPN shortcuts to be established through a UDP hole on a NAT unit. The NAT unit has to support RFC 4787 Endpo...

jvaishnav · 11-10-2020

DescriptionThis article describes the configuration ADVPN with RIP.ScopeFor version 6.4.3.SolutionThis is a sample configuration of ADVPN with RIP as routing protocol. The following options has to be enabled for this configuration:1) On the hub Forti...

jvaishnav · 11-10-2020

Description This article describes the configuration ADVPN with OSPF.Scope For version 6.4.3, and version 7.0.1+.Solution This is a sample configuration of ADVPN with OSPF as the routing protocol. The following options have to be enabled for this con...

User Statistics

User Activity

Technical Tip: IPSec VPN in HA Environment

Technical Tip: OSPF with IPsec VPN for network redundancy

Technical Tip: UDP hole punching for spokes behind NAT

Technical Tip: ADVPN with RIP as the routing protocol

Technical Tip: ADVPN with OSPF as the routing protocol

Technical Tip: 'Device detection' changes

Technical Tip: IBGP and EBGP Support in VRF

Technical Tip: ADVPN with BGP as the routing proto...

Technical Tip: Creating automation stitches

KCS