Description This article describes how to fix an issue where the CPU on
a specific core goes high on SoftIRQ and stops processing traffic. Scope
FortiGate-F series. Solution On the firewall, the CPU on a specific Core
might go high on SoftIRQ. Free m...
Description This article describes how to resolve an issue where the
tunnel interface is not visible in the GUI and cannot be selected in a
firewall policy or in static routes. Scope FortiGate 7.2.5. Solution
This issue is purely cosmetic. It trigger...
Description This article describes that EBGP routes with MED attribute
will not be sent from one EBGP peer to another EBGP peer. Scope FortiOS.
Solution The BGP multiple exit discriminator (MED, or MULTI_EXIT_DISC)
is a non-transitive attribute, mean...
Description This article describes when 'Clone Reverse' is missing in
policy. Scope FortiOS. Solution 'Clone reverse' is not always available
by design. It is hidden when: Action = 'ipsec'. NAT is enabled.
Interface 'any' is selected. VIP is selected...
Hi, config system settingsset dhcp-proxy enableset dhcp-server-ip
"1.1.1.1" "2.2.2.2" end FOS does support multiple server IP addresses to
be configured. Technical Tip: SSL VPN with external DHCP Server -
Fortinet Community Hope the above article ans...
I believe your requirement is to send only HTTP and HTTPS traffic over
the IPsec tunnel. Under phase2 selectors, you can use Remote Port and
Protocol options. Maybe this will help with your requirement.