About gfantappie

gfantappie · 08-18-2013

Description In some customer scenarios, it may be preferred to separate different FortiGate VDOMs across multiple FortiManager ADOMs. This might be required when customers needs to logically separate VDOMs and where different teams in a given organiz...

gfantappie · 10-20-2011

Description This article describes how to configure password authentication and access using a remote TACACS+ server on FortiGate. Scope FortiGate provides support for many remote authentication servers, including TACACS+. If deciding to use a TACACS...

gfantappie · 10-20-2010

DescriptionIn a situation where a FortiManager configuration has been restored, it is not possible to add new devices. When clicking on the "Discovery" button, the following pop-up is displayed : "Failed to discover the device".ScopeAll FortiManager ...

gfantappie · 09-10-2010

Description This article explains how to filter multicast traffic for a specific port range to add more granularity to the multicast flows allowed through the FortiGate. Scope FortiGate (multicast routing) Solution The configuration is done via CLI u...

gfantappie · 06-07-2010

DescriptionThis article describes how to install FortiClient v4.00 MR2 to support IKE Mode Config.ScopeFortiClient v4.00 MR2 and aboveSolutionTo enable IKE Mode Config feature, FortiClient must be installed with the following switch from a Windows co...

User Statistics

User Activity

Technical Tip: How to distribute FortiGate VDOMs in different FortiManager ADOMs

Technical Tip: How to configure TACACS+ authentication and authorization in FortiGate

Troubleshooting Note : Cannot add device after restoring a configuration in FortiManager

Technical Tip : How to filter multicast traffic based on protocol port range

Technical Note : IKE Configuration Method (IKE Mode Config) support on FortiClient 4.0MR2

KCS