Hi, I wasn't sure which topic that my question fell into since it's a
mix of network routing/HA. I found the following error below (some
information is redacted) in my firewall logs. I've done research on what
was actually happening on the firewall a...
Hello, I have been working on setting up 2 Fortigate 200D firewalls in
Active/Passive HA mode and running OSPF. I have attached an image which
shows my current test environment. I have run into an issue where I can
get the failover to occur within 3 ...
We saw this traffic specifically destined to FortiGuard so if it works
similarly to a FortiAnalyzer then it could be. I'm not sure how I would
determine if the FortiGates are running MR7, but we are using HA.
Hello, I've had an opportunity to test with the BFD. I've verified that
the BFD connections were properly working on the wan1 interface. I'm
still experiencing the same issues as before. The failover times between
port2 and wan1 are inconsistent base...
Thank you for the suggestions. Our hello interval is currently 250ms
with the OSPF Fast Hello functionality. I'll look into testing BFD. The
current router we're testing OSPF with is configured to match our
current production environment, so I'm loat...
