Hi Pals, Scenario: FG100E can support 100 concurrent users. For
HA/Clustering setup, let's say for example I have FG100E then configured
as A-A HA, does it increase the number of supported users? Would it be
200 concurrent users in total? Thanks. Reg...
Hi Everyone! Good day! I was trying to work with this scenario and
anyone could help me if this is possible? See attached test.jpg. I have
a FortiGate, a core switch, distribution switch and client pc. The goal
is that FortiGate must act as the DHCP ...
Hi Everyone! Good day!I was trying to work with this scenario and anyone
could help me if this is possible? See attached test.jpg. I have a
FortiGate, a core switch, distribution switch and client pc. The goal is
that FortiGate must act as the DHCP s...
Hello Folks, We are planning to enable/use the FortiGate's Anti-Spam
feature. I have read that Anti-Spam sensor/profile must set prior
applying it to an ipv4 policy. However we are not so sure where on our
firewall policies does the anti-spam feature...
Hi All, I've been preparing for my FortiManager Exam v6.0. Can you
recommend/share with me some practice questions where I can test what I
have studied? Thank you and God Bless. Regards,Kulas
I think you need to make sure that vpn clients can successfully reach
the mitel director and the vpn client ip you wish to call. BTW firewall
is running FortiOS v6.2.3
I used SUBNET instead of IP Range for VPN clients (172.16.10.0). Since
split tunnel was enabled, I added the subnet of vpn clients as routing
address under ssl-vpn portals and created ssl.root to ssl.root firewall
policy. Below was the summary of the...
I have the same concern.. I tried to use SUBNET instead of IP RANGE for
my clients. I do also have firewall policy in placed
ssl.root-to-ssl.root but no traffic hit. I do also debug flow and packet
sniffer but no avail. Regards,Kulas
