Hi all, I have 2 fortigates that I have a IPSEC tunnel between the two.
I am trying to get FGT2 to use FGT1's internet. I know it must be
something simple I'm missing. the Tunnels are up and i can traverse
between the two just fine. for the FGT2 thou...
Forgive if this is loaded somewhere else. I'm running into a snag here.
I am currently on Spectrum and getting a /128 from them. According to my
WAN1 interface. I am trying to get the DHCP to passthrough to my clients
on a vlan, anyone have any luck ...
I have done some digging and haven't really seen anything, so if it has
been posted, im sorry. Currently we have a /29, the fortigate ends with
a 234. I have a couple diff vlans, traffic wise that g out separate
IP's. I would like to make all VPN tra...
So if im not using IPS, why is the helper using the resources? Connected
brecon_60F # diag sys top Run Time: 0 days, 4 hours and 39 minutes 0U,
0N, 0S, 100I, 0WA, 0HI, 0SI, 0ST; 1819T, 339F httpsd 240 S 1.4 7.5
httpsd 247 S 1.4 6.0 ipsengine 235 S < ...
Hey All, Just got a 60f and putting it through the paces. I am noticing
high mem around 60% and if np does anything basically goes to conserve
mode and need to reboot. Scoured cookbook and other googles and cant
seem to find a good NPU best practice....
