Is there an issue with FortiCloud right now? Previously it was working
fine. I could see all my devices and, by clicking on the little "remote
Access" icon, I was able to get on the management interface on the
device. However, since last Friday, I ha...
I have a site to site VPN between the head office and the branch office
that has been working flawlessly for over a year. We have Fortigate
50e's at both ends. The branch office has the built in wifi. At the
branch office there is a wifi network that...
I have a branch office that has a point to point vpn with the head
office. This link has been operating flawlessly for months now. Clients
on either end can communicate with clients on the other end. There is no
nat between the sites. Each branch off...
I have an IPSec tunnel established between two Fortigate 50e's. One is
at our head office and the other at a branch site. The tunnel has been
up for several weeks and traffic crosses the tunnel fine. Clients on one
side are able to ping clients on th...
I have a Fortigate 50 that has been in service for less than a month.
The config on it is very simple, just an internal network of about 15
devices going out the wan1 interface to the public internet.Currently
there is a low end switch plugged into l...
I'm not permitted to open a ticket as I'm using the free services. I
don't have a maintenance contract right now.This has not been a problem
as the free service provides the services I need until recently.
Is there a way to test each step of this. There are the 3 parts that
need to be correct. Actually 6 if I understand correctly because these
settings need to be completed on both sides.Although I think I have
everything set, I just can't seem to get i...
So making changes to a working vpn tunnel may not have any effect? I
have been trying to add the selectors to both sides but still can't get
traffic to pass.
1. I would have assumed that the tunnel (having been setup using the vpn
wizard) would automaticly include the remote sites subnets. Certainly
that worked for the wired networks. That being said, I did create static
routes but didn't see any change. ...
