Hi folks, We are operating a pair of 100D Hardware Appliances (v6.2.4
build 1112 GA), running HA in an Active/Passive configuration and in
Flow Mode. Our FortiGate 100D Appliances sit at the edge of our wireless
network. We recently upgraded to v6.2....
Hi all, We are operating a pair of 100D Hardware Appliances (v6.2.3
build 1066 GA), running HA in an Active/Passive configuration.I recently
had cause to allow access on certain ports to the WAN interface of our
appliances and I accomplished this usi...
Hi all, We are running a pair of 100D Hardware Appliances (v6.2.2 build
1010 GA).I only noticed today that when viewing logs in Log & Report >
Web Filter, Application Control, Local Traffic etc. that the time being
shown on the logs was one hour ahea...
Hi all, We have 2 X 100D Hardware Appliances running firmware version
6.2.1-build 0932 in NAT (Flow-based) Mode (HA: Active-Passive).They are
deployed at the edge of our wireless network and are used for general
Internet access. One of the wireless n...
Hi all, We have 2 X 100D Hardware Appliances running firmware version
6.0.4 (build 0231 GA) in NAT (Flow-based) Mode (HA: Active-Passive).They
primarily protect our wireless network which is open to use by staff and
visiting members of the public. In...
Hi all, Fortinet Support further recommended an upgrade to v6.2.5 as it
may be related to a Known Issue (635589): "From your message I
understood that you have issues that after a while DNS is dropping and
after a while no traffic is possible anymore...
Hi all, We were operating a pair of 100D Hardware Appliances (v6.2.3
build 1066 GA), running HA in an Active/Passive configuration.I noticed
that the Events Log included a lot of entries regarding application
crashes, specifically the IPS Engine.Fort...
Hi all, We upgraded our 100D appliances to 6.2.2 a week ago and noticed
a slight improvement in GUI performance when viewing logs in Log &
Report. However, when filters were applied the CPU once again spiked to
90+% with multiple instances of the 'lo...
Hi all, Just a quick update.Fortinet Support have advised me that they
have been able to replicate my issue and it looks like it is a bug.They
have escalated the support call and passed it to the engineering team
who (hopefully) will be able to get i...
Hi BigEz, The 'Meaningless Content' category is defined, by Fortinet as
"URLs that cannot be definitively categorized due to lack of or
ambiguous content".I'm assuming that your Web Filter Profile is set to
block sites categorized as such.A quick bit...