Hi all,I'm experimenting on v7.2.11 with ADVPN, SD-WAN and BGP on
loopback interfaces. My problem is that I can't understand or find
information on how the underlay interfaces routing should be configured.
Two or four IPSec tunnels are members of the...
Hi all, I have around 45 FortiGates 40F-3G4G with FortiOS version 7.2.11
that I registered with a FortiManager-VM version 7.4.7. It happened to
me about 6 times that our Fortigates lost part of their configuration
after a sudden power outage. All set<!-- --><!-- --><!-- --><!-- -->...
Hi all! I'm currently using FortiGate 800C with firmware v5.2.1 in
transparent mode and created one Ipsec VPN tunnel. Is it possible to
automatically assign IP addresses to VPN clients with FortiClients? I've
checked "set assign-ip-from", "set mode-c...
Hi @jiahoong112 , that's what I do not understand: why set route
priority if I need each IPSec to exit its own assigned interface? But
thanks for links to these articles. As of IPSec with DDNS I did not find
any information about routing to peer in t...
Hi @NetworkR4,Thank you for your answer. We haven't noticed any problems
with lack of free memory. Fortunately, we have not had any new cases of
configuration loss to date. I suspect these might have been one-off
events due to me using FortiZTP to de...
Hi @BillH_FTNT , I sent you configuration by email, thank you for this.
@wokulbo1 We do not have licenses for UTM features, as we use these FG40
only for IPSec and SD-WAN and I did not observe any problems with memory
on them.
Hello, and thanks for answer. emnoc wrote:Your in transparent mode?
PB-vpn are defined by policies for src/dst subnets. Never heard or any
fortigate capable of operating a vpn-server in PB-vpns. I would call FG
unit with defined PB-VPN a vpn-server :...
