My VOIP vendor states that 2% of calls are not getting a response. They
state that it is probably a problem with the "NAT UDP pinhole timeout".
They recommend a value of 60 to 300 seconds. I do not find a place to
set the UDP timeout value. I was hop...
I have a VPN tunnel defined which comes up OK. Traffic on the far side
is coming through the tunnel without a problem (CISCO RV042 device). On
the Fortigate 60D (5.0.310) I have a rule defined where the source is
DMZ, 192.168.18.0/24, destination is ...
I have a block of IPs from my ISP 174.xx.xx.129/27. I have a number of
VIPs and policies set up to direct various of these IPs from WAN1 to the
correct devices on my internal interface. I have a need to give one of
the IPs as-is to another router for...
For anyone following. The document above is talking about the
session-ttl. That is not the same as the UDP or ICMP ttl. So what
finally solved the issue was the following: config sys globalset
udp-idle-timer 300end
That was absolutely the problem. Can't tell you how many times I was
comparing the GUI for this tunnel to other tunnels that worked.
Unfortunately this parameter is not visible in the GUI. I always set up
the tunnels using the GUI never the CLI. Hind...
following configurations cut from a backup showing the relevant parts
(external ip's changed). policy 30 is the one that i assume would push
the traffic down the tunnel but appears to be ignored. rule 31 if
enabled catches the source and destination ...
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
