Hi all Device: Fortigate 60D Firmware 5.2.1 build 618 Until one month
ago we were using only one WAN, connected to one ISP. We were using some
public ip addresses and with the appropriate policy it was possible to
connect to some websites hosted inte...
Hi all(sorry for the long post but I tried to explain a very strange
problem...) After a power outage in our remote office I'm having some
strange problems with the VPN connection between our Headquarter (HQ)
and our remote office (RO) Our HQ has a F...
Hi all we have a Fortigate 60C already running configured witn ISP A
(wan1). Interface addressing mode is configured to "Manual" Now we want
to configure another connection (with another ISP) and we have connected
to wan2. Interface addressing mode i...
Hi all in our company we have headquarter: Fortigate FGT 60D firmware
5.2.1 branch office: Fortigate FGT 60C firmware 5.2.1 Headquarter and
branch office are connected with a Site-to-site VPN tunnel (used for PCs
network and also for voip) both are u...
Hi all in our office (branch office) we have a Fortigate 60C and we are
currently connected on one only ISP; FGT-60C configuration is quite
simple: all internal traffic goes to wan1 There is also a static VPN
configured with our headquarter so we hav...
Hi allsolved !It was, as you suggested, a problem of policy; one of them
was incorrectWhat I don't understand is that, as I said, I did not
change anything on policies after power outage as I was thinking that
everithing was correctly configured and ...
Yes, I have tried to bring the tunnel down and then back upI tried to
reboot both firewallsPolisies are in place and enabled and they show up
in the routing monitor (see attached image)I'm running out of
ideas..Maybe I could try to delete these route...
I configured as you said and it is perfectly working, thank you !(I
still have some questions on how to configure redundant vpn, load
balancing, etc, but I'll open new discussions on it, I hope you can help
me again )
Thank youjusta nother detail; currently there is a static route
configured for my wan1Destination : 0.0.0.0Gateway: my ISP
gatewayInterface: wan1 Do i need to change/modify/remove it ?
Can you give some more details on these 2 steps ? (I'm quite a newbie)
Create a new policy route going to your HQ network from destination
interface internal and set it to Stop Policy Routing Create a new policy
route going to 0.0.0.0/0.0.0.0 with de...
